Buddy3D camera in B/W
I've just installed Buddy3D camera to my Core One successfully. Well, as long as the magnets hold which I have little confidence in!
But ... image is b/w only. I know there's something written about an update to colour in new f/w sometime, BUT the first image after powering on the Core One comes through in colour, and subsequent ones in b/w. So mabe the f/w is partly fixed ?? FWIW my camera f/w is 3.1.0. Any suggestions ?
RE: Buddy3D camera in B/W
OK, as often happens, I have answered this myself ...
The camera was in auto mode and defaulting to IR. I (eventually found) how to switch it to "day" and colour is restored. Good.
Not so good: Prusa's instructions for installing the camera to the Core One are in the knowledgebase. And towards the end is a basic section about setting up the camera wifi etc. That all worked for me. But now I find that there's a much more comprehensive knowledgebase article, about setting up the camera. If I'd known about that the previous problem would not have occurred.
Prusa: you really should delete the very basic instructions on the Core One camera page and point the users at the other knowledgebase article.