Notifications
Clear all
Issue with new FS Cover when building Prusa Enclosure for MK3S
I'm enjoying the new enclosure, but when I went to install the new FS cover, then M3x10 screw that holds it in place no longer fits tightly into the extruder and the cover is very loose. Any thoughts on how to tighten up this screw as the hole is now too big/loose ? (Would a drop of locktite hold it in place, but allow me to remove it in the future ?)
Not looking to rebuild the extruder head if possible 🙂 I been printing for the last 9 hours and it seems to be fine (pulling the filament into the head does not seem to have any issues).
Thanks for any thoughts - Ward
Napsal : 27/11/2025 11:43 pm