Superpinda upgrade - first layer problems - Assembly and first prints troubleshooting https://forum.prusa3d.com/forum/assembly-and-first-prints-troubleshooting/superpinda-upgrade-first-layer-problems/ Prusa3D Forum Discussion Board en-US Sat, 06 Jun 2026 14:22:51 +0000 wpForo 60 RE: Superpinda upgrade - first layer problems https://forum.prusa3d.com/forum/assembly-and-first-prints-troubleshooting/superpinda-upgrade-first-layer-problems/#post-696757 Tue, 30 Jan 2024 08:54:08 +0000 0.042mm difference isn't a lot. The Mini can compensate for +-1mm.

How is your extruder gears teeth looking? I have had the same uneven extrusion issue when I noticed that it wasn't clean. Also might need to check that the gears in the extruder has a goog play and that the gear that sits on the motor is screwed in tight.

]]> Assembly and first prints troubleshooting Tysonsw https://forum.prusa3d.com/forum/assembly-and-first-prints-troubleshooting/superpinda-upgrade-first-layer-problems/#post-696757 Superpinda upgrade - first layer problems https://forum.prusa3d.com/forum/assembly-and-first-prints-troubleshooting/superpinda-upgrade-first-layer-problems/#post-692826 Fri, 05 Jan 2024 14:15:19 +0000 To achieve a perfect first layer I've just upgraded my probe to a superpinda. Unfortunately, the new probe doesn't do anything for me, as the bed levelness (0.042mm max difference across the bed) is still an issue. I've also installed a silicone mod, but can't get rid of a low spot (pic attached), resulting in gaps responding to the low spot it seems. I was under the impression that the variance of my silicone mod is still far better than the original mountings and the superpinda would be able to do the rest in terms of mesh bed leveling. Also, I've noticed visible differences in the first layer (streaks). I've run the first test at 200/60, the second one at 210/60 (gaps are worese). Grateful for any tips or insights to achieve a (near) perfect layer!

PLA 200 Nozzle 160 Bed PLA 200 Nozzle 160 Bed PLA 210 Nozzle 160 Bed PLA 210 Nozzle 160 Bed PLA 200 Nozzle 160 Bed

]]> Assembly and first prints troubleshooting didier.l https://forum.prusa3d.com/forum/assembly-and-first-prints-troubleshooting/superpinda-upgrade-first-layer-problems/#post-692826