Notifications
Clear all

PINDA height  

  RSS
alidaf
(@alidaf)
Trusted Member
PINDA height

I had to adjust the nozzle height by a smidge over 1.8mm to get anywhere near a decent calibration print. Is this still ok or should I change the PINDA height?

Posted : 03/09/2021 1:59 pm
jcjames_13009
(@jcjames_13009)
Estimable Member
Prusa's recommendations

Hi

You'll find Prusa's recommendations in the knownledge db -> https://help.prusa3d.com/en/guide/7-preflight-check_204705

JC

Posted : 03/09/2021 2:29 pm
Share: