Notifications
Clear all
Page 2 / 2
Prev
.bgcode doesn't include settings, just motor commands...
but luckily, if you have the .gcode file, Prusa include the settings as comments; so open it in a text editor - most of the settings are at the end of the file.
Cheerio,
Posted : 29/08/2024 3:39 am
fabnavigator liked
RE: INCREDIBLY frustrated
I've been having very similar issues since the last updates. I would like to know if you found out what your final changes were that may have gotten the blemish to go away from Benchy's bow. I was getting flawless prints until I installed the updates. Now non-IS and IS prints have blemishes and a horrible vertical line on Benchy's stern. Thank you!
Posted : 29/08/2024 4:56 pm
Page 2 / 2
Prev