English
Forums
Members
zzjlamb
Activity
 
Notifications
Clear all
zzjlamb
zzjlamb
Group: Registered
Joined: 2021/10/14
Active Member
1
Profile Activity
I replaced the nozzle, which seemed to fix the problem. I ha...

In forum General discussion, announcements and releases

 1 year ago
I've got the same question. Prusament PLA prints much fast a...

In forum Input Shaper (MK4)

 2 years ago
I checked my idler axle after Henry's post above, and there ...

In forum General discussion, announcements and releases

 3 years ago
I've just started using my MMU2S with the Revo 6. I'm not ...

In forum General discussion, announcements and releases

 3 years ago
I started getting the same thing. Only on the first layer. P...

In forum Hardware, firmware and software help

 3 years ago
Faster because reduced travel. On standard settings the nozz...

In forum PrusaSlicer

 4 years ago
Can gap fill be done immediately after the solid infill area...

In forum PrusaSlicer

 4 years ago
I had the same question. I found the placeholder which does ...

In forum PrusaSlicer

 4 years ago
I dried the filament in a food dryer at 45C for 2 hours. The...

In forum Assembly and first prints troubleshooting

 4 years ago
I opened a brand new roll of Prusament PETG yesterday and pr...

In forum Assembly and first prints troubleshooting

 4 years ago
I have the same question as Tentama. I used Simplify 3D befo...

In forum General discussion, announcements and releases

 4 years ago
Hi Neophyl. Thanks for the tip. The new "Snug" option in PS2...

In forum PrusaSlicer

 4 years ago
Thanks for the suggestion Rick, but unfortunately support bl...

In forum PrusaSlicer

 4 years ago
I'm having a similar problem, but my support isn't attached ...

In forum PrusaSlicer

 4 years ago
Share: