|
Hi all,
On my three and a half year old, non Prusa, i3 clon... In forum Hardware, firmware and software help |
6 years ago |
|
I have a MK2 and a MK3 and this weekend i have been printing... In forum General discussion, announcements and releases |
6 years ago |
|
I have printed Rigid Ink TPU which is very flexible without ... In forum General discussion, announcements and releases |
7 years ago |
|
Ahh, yes. Should have aso mentioned the filament sensor is ... In forum General discussion, announcements and releases |
7 years ago |
|
I have a MK2S and a MK3 (and a I3 clone i have had for three... In forum General discussion, announcements and releases |
7 years ago |
|
In a word, Yes.
I bought a MK2 about a month before the MK3... In forum General discussion, announcements and releases |
7 years ago |
|
Hi,
I have successfully printed a part about 75mm across in... In forum Others (Archive) |
7 years ago |
|
I too have had problems with white filament but have not had... In forum Others (Archive) |
7 years ago |
|
If the Prusa firmware supports the M42 (I think) command cou... In forum Improvements (Archive) |
7 years ago |
|
Sorry all, me being a dummy. I did not realise there was an... In forum Others (Archive) |
7 years ago |
|
Strange Slic3r issue following installation of MK3 software In forum Others (Archive) |
7 years ago |
|
+1 for build to original spec.
I consider myself fairly "up... In forum Others (Archive) |
7 years ago |
|
I printed one of these for my MK3, well two actually as I gu... In forum Others (Archive) |
7 years ago |
|
It is a flexible TPU from Rigid Ink in the UK
Z In forum Others (Archive) |
7 years ago |
|
Hi,
It took me about eight hours. The only gotcha was I in... In forum Others (Archive) |
7 years ago |
|
I was reading this thread earlier today and decided when I g... In forum Others (Archive) |
7 years ago |
|
Just finished building my Mk3 In forum Others (Archive) |
7 years ago |
|
Ordered min on Friday. It was only a month ago I had my MK2... In forum General discussion, announcements and releases |
7 years ago |
|
DOH! Knew it would be simple! I had tracked down the file... In forum Print tips (Archive) |
7 years ago |
|
Slic3r print settings In forum Print tips (Archive) |
7 years ago |
