zbrozek – Aktywność – Prusa3D Forum

Notifications

Clear all

zbrozek

Grupa: Zarejestrowany

Dołączył: 2018/01/27

Trusted Member

	Inconsistent layer quality - missing steps on X/Y axes? In forum Others (Archive)	7 years temu
	The bed has a nominal resistance of 1 Ohm. That means at 12... In forum Others (Archive)	7 years temu
	I'm actually unconvinced this has much to do with the MMU de... In forum Others (Archive)	7 years temu
	I found the schematic for the stepper switch: It looks lik... In forum Others (Archive)	7 years temu
	MK2S MMU: What limits system voltage? In forum Others (Archive)	7 years temu
	So, what's the best workaround? Just run the code off the SD... In forum Others (Archive)	7 years temu
	Did you give it a shot? It looks like there's a thread where... In forum Improvements (Archive)	7 years temu
	How's the tension on your Y-axis belt? In forum Others (Archive)	7 years temu
	Indeed - I read that but wasn't sure what to make of it. In forum Others (Archive)	7 years temu
	Totally normal, carry on. In forum Others (Archive)	7 years temu
	MK2S queuing unwanted commands after M601 + M1 + M602 In forum Others (Archive)	7 years temu

Strona 4 / 4 Wstecz

Statystyki Forum

565 Fora

63.9 K Tematy

447.7 K Posty

18 Online

69.6 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte