Polski
Fora
Członkowie
Yngeinstn
Aktywność
 
Notifications
Clear all
Yngeinstn
Yngeinstn
Grupa: Zarejestrowany
Dołączył: 2018/11/11
Eminent Member
2
Profil Aktywność
“gcode not sliced for this machine” warning message

In forum General discussion, announcements and releases

 6 years temu
Question? Is the nozzle supposed to make contact with the st...

In forum Assembly and first prints troubleshooting

 6 years temu
So far so good. I did the built-in Live -Z adjust and then p...

In forum Assembly and first prints troubleshooting

 6 years temu
Ah, Yes.. I was just unfamiliar with the use of the term. I...

In forum Assembly and first prints troubleshooting

 6 years temu
Thank you both.. I am confused though.. What is the differen...

In forum Assembly and first prints troubleshooting

 6 years temu
Thanks for the explanation. So does that mean 1) i set P.I.N...

In forum Assembly and first prints troubleshooting

 6 years temu
It appears that no matter what i do i am ~1.700 away from th...

In forum Assembly and first prints troubleshooting

 6 years temu
Indeed it does however i lowered it an few notches (threads)...

In forum Assembly and first prints troubleshooting

 6 years temu
Z Axis Calibration - Problems

In forum Assembly and first prints troubleshooting

 6 years temu
bobstro, You sir, are a genius. I would have never known if...

In forum Hardware, firmware and software help

 7 years temu
peter.k42, I am not sure what RPi is, can you please elabor...

In forum Hardware, firmware and software help

 7 years temu
Thanks for the quick response. Yes this morning it I was thi...

In forum Hardware, firmware and software help

 7 years temu
MK3 Not Reponding

In forum Hardware, firmware and software help

 7 years temu
Strona 2 / 2
Share: