Français
Forums
Membres
Yngeinstn
Activité
 
Notifications
Clear all
Yngeinstn
Yngeinstn
Groupe: Enregistré
A(ont) rejoint: 2018/11/11
Eminent Member
2
Profil Activité
“gcode not sliced for this machine” warning message

Dans le forum General discussion, announcements and releases

 il y a 5 years
Question? Is the nozzle supposed to make contact with the st...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
So far so good. I did the built-in Live -Z adjust and then p...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Ah, Yes.. I was just unfamiliar with the use of the term. I...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Thank you both.. I am confused though.. What is the differen...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Thanks for the explanation. So does that mean 1) i set P.I.N...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
It appears that no matter what i do i am ~1.700 away from th...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Indeed it does however i lowered it an few notches (threads)...

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
Z Axis Calibration - Problems

Dans le forum Assembly and first prints troubleshooting

 il y a 5 years
bobstro, You sir, are a genius. I would have never known if...

Dans le forum Hardware, firmware and software help

 il y a 6 years
peter.k42, I am not sure what RPi is, can you please elabor...

Dans le forum Hardware, firmware and software help

 il y a 6 years
Thanks for the quick response. Yes this morning it I was thi...

Dans le forum Hardware, firmware and software help

 il y a 6 years
MK3 Not Reponding

Dans le forum Hardware, firmware and software help

 il y a 6 years
Page 2 / 2
Partager :