Deutsch
Foren
Mitglieder
Yngeinstn
Aktivität
 
Benachrichtigungen
Alles löschen
Yngeinstn
Yngeinstn
Gruppe: Registriert
Beigetreten: 2018/11/11
Eminent Member
2
Profil Aktivität
“gcode not sliced for this machine” warning message

Im Forum General discussion, announcements and releases

 Vor 6 years
Question? Is the nozzle supposed to make contact with the st...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
So far so good. I did the built-in Live -Z adjust and then p...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Ah, Yes.. I was just unfamiliar with the use of the term. I...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Thank you both.. I am confused though.. What is the differen...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Thanks for the explanation. So does that mean 1) i set P.I.N...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
It appears that no matter what i do i am ~1.700 away from th...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Indeed it does however i lowered it an few notches (threads)...

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
Z Axis Calibration - Problems

Im Forum Assembly and first prints troubleshooting

 Vor 6 years
bobstro, You sir, are a genius. I would have never known if...

Im Forum Hardware, firmware and software help

 Vor 7 years
peter.k42, I am not sure what RPi is, can you please elabor...

Im Forum Hardware, firmware and software help

 Vor 7 years
Thanks for the quick response. Yes this morning it I was thi...

Im Forum Hardware, firmware and software help

 Vor 7 years
MK3 Not Reponding

Im Forum Hardware, firmware and software help

 Vor 7 years
Seite 2 / 2
Teilen: