English
Forums
Members
Yngeinstn
Activity
 
Notifications
Clear all
Yngeinstn
Yngeinstn
Group: Registered
Joined: 2018/11/11
Eminent Member
2
Profile Activity
“gcode not sliced for this machine” warning message

In forum General discussion, announcements and releases

 5 years ago
Question? Is the nozzle supposed to make contact with the st...

In forum Assembly and first prints troubleshooting

 5 years ago
So far so good. I did the built-in Live -Z adjust and then p...

In forum Assembly and first prints troubleshooting

 5 years ago
Ah, Yes.. I was just unfamiliar with the use of the term. I...

In forum Assembly and first prints troubleshooting

 5 years ago
Thank you both.. I am confused though.. What is the differen...

In forum Assembly and first prints troubleshooting

 5 years ago
Thanks for the explanation. So does that mean 1) i set P.I.N...

In forum Assembly and first prints troubleshooting

 5 years ago
It appears that no matter what i do i am ~1.700 away from th...

In forum Assembly and first prints troubleshooting

 5 years ago
Indeed it does however i lowered it an few notches (threads)...

In forum Assembly and first prints troubleshooting

 5 years ago
Z Axis Calibration - Problems

In forum Assembly and first prints troubleshooting

 5 years ago
bobstro, You sir, are a genius. I would have never known if...

In forum Hardware, firmware and software help

 6 years ago
peter.k42, I am not sure what RPi is, can you please elabor...

In forum Hardware, firmware and software help

 6 years ago
Thanks for the quick response. Yes this morning it I was thi...

In forum Hardware, firmware and software help

 6 years ago
MK3 Not Reponding

In forum Hardware, firmware and software help

 6 years ago
Page 2 / 2
Share: