Activity
 
Notifications
Clear all
YigalB
YigalB
Group: Registered
Joined: 2020/12/04
Eminent Member
2
Can the Flash drive be removed while printing?

In forum General discussion, announcements and releases

3 years ago
I am using eSun PLA+ True, the actual number is not a releva...

In forum How do I print this? (Printing help)

3 years ago
Thank you! Very detailed and informative. There is so much t...

In forum How do I print this? (Printing help)

3 years ago
print fail although with support

In forum How do I print this? (Printing help)

3 years ago
Network connection with Prusa Mini

In forum General discussion, announcements and releases

3 years ago
@BogdanH Aha, good point. I was sure that the separation mea...

In forum General discussion, announcements and releases

3 years ago
Thanks ! I will check it. Sounds like a cool solution.

In forum General discussion, announcements and releases

3 years ago
Thanks for the reply. My Prusa Mini gave some suffer time un...

In forum General discussion, announcements and releases

3 years ago
First layer calibration

In forum General discussion, announcements and releases

3 years ago
True. However, I am trying to save my time, not the printer'...

In forum General discussion, announcements and releases

4 years ago
Sorry guys, I meant something else. I don't want to change t...

In forum General discussion, announcements and releases

4 years ago
Temperature changes between print/calibration/idle

In forum General discussion, announcements and releases

4 years ago
Please take a look at the extruder after opening it: does th...

In forum Hardware, firmware and software help

4 years ago
@texy Not yet, because I think the problem is earlier: the f...

In forum Hardware, firmware and software help

4 years ago
More inputs from my side: following the guide, I heated the ...

In forum Hardware, firmware and software help

4 years ago
@karl-herbert Thank you for the fast answer. I read the tips...

In forum Hardware, firmware and software help

4 years ago
Filament is not going out of nozel

In forum Hardware, firmware and software help

4 years ago
Page 2 / 2
Share: