Notifications
Clear all
Yeshead
Skupina: Registrovaný
Přidal se: 2020/12/11
Active Member
1
| Modeling for MMU2S | před 4 years | |
|
Hello All, I tried wash it with soap and hot water. It helpe... In forum Hardware, firmware and software help |
před 4 years | |
|
Strange adhesion problem In forum Hardware, firmware and software help |
před 4 years | |
| If I look at yout test prints, I think they are too thick. T... | před 5 years | |
| Hello again, I found the solution, thanks to jeffjordan tes... | před 5 years | |
| Bad adhesion printbed | před 5 years |