Activity
 
Notifications
Clear all
xt550
xt550
Group: Registered
Joined: 2019/03/30
Active Member
1
a tiny bit ABS in the extruder ,had to heat it up with a blo...

In forum How do I print this? (Printing help)

4 years ago
horizontal print separation

In forum How do I print this? (Printing help)

4 years ago
Im using 0,6mm brass nozzle with a silicon "glove"

In forum How do I print this? (Printing help)

4 years ago
ABS problem

In forum How do I print this? (Printing help)

4 years ago
I would like another extruder with the holes for the heater ...

In forum General discussion, announcements and releases

5 years ago
after runing the calibration again it sems to work agan

In forum Hardware, firmware and software help

6 years ago
And Prusa Slicer 2

In forum Hardware, firmware and software help

6 years ago
M3s rebooting loading gcode

In forum Hardware, firmware and software help

6 years ago
I changed the nozzle to 0,6 and increased bed and nozzle tem...

In forum Assembly and first prints troubleshooting

6 years ago
i tried, still getting blobs and i have to go below -0.6 for...

In forum Assembly and first prints troubleshooting

6 years ago
Just did that, raised the z to -0.5 the first 1/3 of the squ...

In forum Assembly and first prints troubleshooting

6 years ago
Here is as see through i think its a quite even until the tr...

In forum Assembly and first prints troubleshooting

6 years ago
thank you for the fast answer. but it seams like the first l...

In forum Assembly and first prints troubleshooting

6 years ago
some thoughts and a problem

In forum Assembly and first prints troubleshooting

6 years ago
it there a recomended distance betwin the hotend and the co...

In forum Hardware, firmware and software help

6 years ago
it or i messed up

In forum Hardware, firmware and software help

6 years ago
Great build volume – 11,025 cm3 (25 x 21 x 21 cm) And 1 kg (...

In forum General discussion, announcements and releases

6 years ago
"stupid" newbie questions

In forum General discussion, announcements and releases

6 years ago
Share: