|
Yes, I read that when I needed to do a cold pull due to curl... Nel forum Hardware, firmware and software help |
7 years fa |
|
So I opened the extruder, was like this:
Managed to pull... Nel forum Hardware, firmware and software help |
7 years fa |
|
Printing in air, filament feed failure, won't unload either.... Nel forum Hardware, firmware and software help |
7 years fa |
|
Here is mine. The psu wires are too short. I have longer cab... Nel forum User mods - OctoPrint, enclosures, nozzles, ... |
7 years fa |
|
You mean like this?
I didn't find a 0.8mm one, not sure i... Nel forum General discussion, announcements and releases |
7 years fa |
|
Thanks. I was heating both at once as per the standard out ... Nel forum Hardware, firmware and software help |
7 years fa |
|
Bob, that's a great article.
I was thinking that given I do... Nel forum General discussion, announcements and releases |
7 years fa |
|
Start G-Code Mods to speed up process (and prevent dripping) Nel forum Hardware, firmware and software help |
7 years fa |
|
Effects of Increasing Printer Speed Nel forum General discussion, announcements and releases |
7 years fa |
|
I know this won't make you feel better, but I ordered in Ita... Nel forum General discussion, announcements and releases |
7 years fa |
|
What's that about calibration square... Nel forum Hardware, firmware and software help |
7 years fa |
|
So, as stated, I got the self-extrusion sorted by not heatin... Nel forum Hardware, firmware and software help |
7 years fa |
|
Thanks.
Jbinfl, this was a fresh opened roll from a good ma... Nel forum Hardware, firmware and software help |
7 years fa |
|
I would be a little careful about just using this posted cod... Nel forum Hardware, firmware and software help |
7 years fa |
|
I have just discovered and understood this too. Although it... Nel forum Assembly and first prints troubleshooting |
7 years fa |
|
I have the nozzle far away, I filmed it a bit - rough editin... Nel forum Hardware, firmware and software help |
7 years fa |
|
Thanks, I tried that, and it didn't seem to help. I also cl... Nel forum Hardware, firmware and software help |
7 years fa |
|
Sudden failure laying down filament Nel forum Hardware, firmware and software help |
7 years fa |
