|
Yes, I read that when I needed to do a cold pull due to curl... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
So I opened the extruder, was like this:
Managed to pull... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Printing in air, filament feed failure, won't unload either.... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Here is mine. The psu wires are too short. I have longer cab... Im Forum User mods - OctoPrint, enclosures, nozzles, ... |
Vor 7 years |
|
You mean like this?
I didn't find a 0.8mm one, not sure i... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
Thanks. I was heating both at once as per the standard out ... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Bob, that's a great article.
I was thinking that given I do... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
Start G-Code Mods to speed up process (and prevent dripping) Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Effects of Increasing Printer Speed Im Forum General discussion, announcements and releases |
Vor 7 years |
|
I know this won't make you feel better, but I ordered in Ita... Im Forum General discussion, announcements and releases |
Vor 7 years |
|
What's that about calibration square... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
So, as stated, I got the self-extrusion sorted by not heatin... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Thanks.
Jbinfl, this was a fresh opened roll from a good ma... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
I would be a little careful about just using this posted cod... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
I have just discovered and understood this too. Although it... Im Forum Assembly and first prints troubleshooting |
Vor 7 years |
|
I have the nozzle far away, I filmed it a bit - rough editin... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Thanks, I tried that, and it didn't seem to help. I also cl... Im Forum Hardware, firmware and software help |
Vor 7 years |
|
Sudden failure laying down filament Im Forum Hardware, firmware and software help |
Vor 7 years |
