Notifications
Clear all
Wassini
Wassini
Group: Registered
Joined: 2019/07/26
Active Member
1
Sure - but this flyer might be lost. Looking at the site I c...

In forum Assembly and first prints troubleshooting

5 years ago
@lichtjaeger Ah.. It was the only forum that contained "Mult...

In forum Assembly and first prints troubleshooting

5 years ago
I don't know what part of the link you are thinking is usefu...

In forum Assembly and first prints troubleshooting

5 years ago
Build Instructions?

In forum Assembly and first prints troubleshooting

5 years ago
I susspect that you mean 32Gb 😉 It's the 8 Gb USB stick th...

In forum Hardware, firmware and software help

5 years ago
This did work!

In forum Hardware, firmware and software help

5 years ago
Upsating Firmware not possible: Error mounting USB drive

In forum Hardware, firmware and software help

5 years ago
I had to heat it to 290°C and use a small metalpin to remove...

In forum How do I print this? (Printing help)

5 years ago
ASA gets stuck in heater/can't load filament

In forum How do I print this? (Printing help)

5 years ago
@zoltan Yes - adjusting the Z level helped a lot. Now I only...

In forum How do I print this? (Printing help)

5 years ago
Problem with the steel plate

In forum How do I print this? (Printing help)

5 years ago
It seems that this "fix through the Netfabb" did fix the pro...

In forum Hardware, firmware and software help

5 years ago
Ah! It didn't allow me to upload STL files. I forgot all abo...

In forum Hardware, firmware and software help

5 years ago
Problem with slicer

In forum Hardware, firmware and software help

5 years ago
Share: