Notifications
Clear all
w531t4
Group: Registered
Joined: 2022/01/09
Active Member
1
Check out the following -br />-/p> In forum PrusaSlicer |
4 months ago | |
sigh... so much *winning* /s | 4 months ago | |
here here. same boat, same place, same week, same lack of co... | 4 months ago | |
That’s an interesting take. Ty | 5 months ago | |
contacted support, it's a known issue and is being worked. In forum Bugs & Errors |
5 months ago | |
mine, too. mk4 In forum Bugs & Errors |
5 months ago | |
Best chance to reduce PETG warping | 5 months ago | |
Sorry to bump an old thread - however i have a bit more insi... | 2 years ago | |
I've also taken a minute to map various parameters to what t... | 4 years ago | |
Also, i'll note that i'm running mk3s+ w/ mmu2s (factory ass... | 4 years ago | |
Wanted to take a moment to complement OP on their post which... | 4 years ago |