Prusa3D Forum

Notifications

Clear all

veloaddict

Groupe: Enregistré

A(ont) rejoint: 2025/02/22

Active Member

	I ended up upgrading the original bearings for X and Y axis,... Dans le forum General discussion, announcements and releases	il y a 7 months
	In the 2nd picture, the one from the top, the infill in in t... Dans le forum General discussion, announcements and releases	il y a 7 months
	Nothing is lifting/lifted. The filament is brand new out of ... Dans le forum General discussion, announcements and releases	il y a 7 months
	The part is stuck to the bed, no adhesion problems, no lifts... Dans le forum General discussion, announcements and releases	il y a 7 months
	Yes, same file used to print. Dans le forum General discussion, announcements and releases	il y a 7 months
	No issues when using Prusament Galaxy Black. Dans le forum General discussion, announcements and releases	il y a 7 months
	Now I found out that the perimeter has separation. Dans le forum General discussion, announcements and releases	il y a 7 months
	waves in vertical prints Dans le forum General discussion, announcements and releases	il y a 7 months

Statistiques du forum

585 Forums

68.2 K Sujets

477.8 K Messages

10 En-ligne

76 K Membres

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé