Prusa3D Forum

Notifications

Clear all

uofmrob

Group: Registered

Joined: 2020/08/26

Active Member

	Also, when I went flashed to the MK3 firmware, it passed the... In forum Hardware, firmware and software help	4 years ago
	Ha! I let Prusa know that I had tried to isolate a bad PINDA... In forum Hardware, firmware and software help	4 years ago
	Thanks! I'll check that. In not sure if it's the issue, toug... In forum Hardware, firmware and software help	4 years ago
	Thanks for the advice. However, it doesn't seem to have help... In forum Hardware, firmware and software help	4 years ago
	Great, thanks, Joan! I'll give this a shot! In forum Hardware, firmware and software help	4 years ago
	Z calibration failure In forum Hardware, firmware and software help	4 years ago

Forum Statistics

559 Forums

63.1 K Topics

443.9 K Posts

22 Online

68.1 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed