|
Being the one that started this thread, I had no idea it wou... In forum Hardware, firmware and software help |
3 years ago |
|
Thanks to all that replied. The new SuperPINDA arrived yes... In forum Hardware, firmware and software help |
3 years ago |
|
Thanks! I'll have to check out that M3-18 screw mod. Than... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
I should have the new SPinda by the end of the week so I wil... In forum Hardware, firmware and software help |
3 years ago |
|
I did 🙂 Both are 3-pin plugs. Both have a "Superpinda" la... In forum Hardware, firmware and software help |
3 years ago |
|
They are both MK3s+ models for sure. Slow printer was shi... In forum Hardware, firmware and software help |
3 years ago |
|
Who said I'm not prepared to check electronics? All I said... In forum Hardware, firmware and software help |
3 years ago |
|
This was a great catch!!! I had not noticed that, but you ar... In forum Hardware, firmware and software help |
3 years ago |
|
I have not swapped pindas, as I do not want to unnecessarily... In forum Hardware, firmware and software help |
3 years ago |
|
This printer has been this way since it was new. I've also ... In forum Hardware, firmware and software help |
3 years ago |
|
Thanks Robin. Keep in mind, I am now using a nut driver (s... In forum Hardware, firmware and software help |
3 years ago |
|
So update, I worked with Prusa support on this for a couple ... In forum Hardware, firmware and software help |
3 years ago |
|
Yup, got that 🙂 In the photo above of the cleaned up hot e... In forum Hardware, firmware and software help |
3 years ago |
|
To tie the sock up and keep it from sagging over time, I use... In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Best of Both Worlds E3D V6 Sock Mod In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Simple Ball Bearing Side-Mount Filament Guide In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
These are awesome, thank you for sharing this!!!!!! In forum User mods - OctoPrint, enclosures, nozzles, ... |
3 years ago |
|
Also, I am hot-tightening at 290C (295C this last time now) ... In forum Hardware, firmware and software help |
3 years ago |
|
Thanks for the replies!! I'm aware of the need to leave a g... In forum Hardware, firmware and software help |
3 years ago |
|
Additional info - I am printing Overture and Prusament PETG ... In forum Hardware, firmware and software help |
3 years ago |
