TTGG – Activité – Prusa3D Forum

Notifications

Clear all

TTGG

Groupe: Enregistré

A(ont) rejoint: 2017/10/11

Eminent Member

	I would like to add something I discovered over the last sev... Dans le forum Others (Archive)	il y a 7 years
	Just wanted to add another name to the list of failed power ... Dans le forum Hardware, firmware and software help	il y a 7 years
	I would just like to add myself to the list of PSU failure. ... Dans le forum Hardware, firmware and software help	il y a 7 years
	in 3.1.2RC1 and I am seeing the same problem with numbers th... Dans le forum Others (Archive)	il y a 7 years
	Over the last several days (primarily printing from Octoprin... Dans le forum Others (Archive)	il y a 7 years
	Over the last several days (primarily printing from Octoprin... Dans le forum Others (Archive)	il y a 7 years
	I know Prusa has put a lot of effort to try and make this se... Dans le forum Others (Archive)	il y a 7 years
	Just a question about OctoPrint and the filament sensor. Is... Dans le forum General discussion, announcements and releases	il y a 7 years
	I went back to USB between Pi3 and the MK3 and completely er... Dans le forum Others (Archive)	il y a 7 years
	I went back to USB between Pi3 and the MK3 and completely er... Dans le forum Others (Archive)	il y a 7 years
	I am on the latest release of the firmware for the MK3 and I... Dans le forum Others (Archive)	il y a 7 years
	After upgrading to the latest firmware I was able to success... Dans le forum General discussion, announcements and releases	il y a 7 years
	Last night I upgraded to the latest fw release and re-attemp... Dans le forum General discussion, announcements and releases	il y a 7 years
	Just wanted to report my experience. Not too long ago I rec... Dans le forum General discussion, announcements and releases	il y a 7 years
	I had this happen to me several times. I noticed that someti... Dans le forum Others (Archive)	il y a 7 years
	I just started printing with Matterhackers Black PETG in the... Dans le forum Others (Archive)	il y a 7 years
	Problems that still stand: Slightly rough top layers Beginn... Dans le forum General discussion, announcements and releases	il y a 7 years
	I just started to print with my MK3 using S3D and I noticed ... Dans le forum General discussion, announcements and releases	il y a 7 years

Page 2 / 2 Précédent

Statistiques du forum

565 Forums

64.5 K Sujets

451.7 K Messages

21 En-ligne

71.1 K Membres

Le dernier des messages: 0.4MM Nozzle - 0.3MM Layer Height Gone?! Notre nouveau membre: baztm Messages récents Messages non lus Balises

Icones du forum: Le forum ne contient pas de messages non lus Le forum contient des messages non lus

Icones du sujet: Sans réponse Repondu Actifs Au top Épinglé Non approuvé Résolu Privé Fermé