Notifications
Clear all
tonyk
Skupina: Registrovaný
Přidal se: 2022/09/26
Eminent Member
2
| Ok, so I didn't have the steel sheet on the print bed during... | před 2 years | |
| Heater Test fails | před 2 years | |
| Thanks everybody, great feedback! I'm actually super happy w... | před 2 years | |
| What happens when filament runs out? How easy is extraction ... | před 3 years | |
|
Same here. Reverted back to 3.9.3 without factory reset and ... In forum Hardware, firmware and software help |
před 3 years | |
| Need help understanding reasons for these print artefacts | před 3 years |
Stránka 2 / 2
Předchozí