Notifications
Clear all
todd.m2
todd.m2
Group: Registered
Joined: 2016/05/16
Eminent Member
2
Glad to hear! How did you adjust the X- axis to line up with...

In forum Others (Archive)

8 years ago
Issue with Cura file

In forum Others (Archive)

8 years ago
Glad to hear! How did you adjust the X- axis to line up with...

In forum Others (Archive)

8 years ago
My X-Axis is to the left exactly the same as yours and I hav...

In forum Others (Archive)

8 years ago
Thanks Anderson!

In forum Others (Archive)

8 years ago
Questions about Cura, Simplify3D and Slic3r..

In forum Others (Archive)

8 years ago
I was printing a part I converted to gcode in Cura and the p...

In forum General discussion, announcements and releases

8 years ago
What are the exact problems? Same problems as mentioned wit...

In forum Others (Archive)

8 years ago
Advice and Settings for printing Ninjaflex?

In forum Others (Archive)

8 years ago
I love that Dragon! Which file is that? Adalinda, bundled wi...

In forum Others (Archive)

8 years ago
Any advice on Cura Settings for Ninjaflex?

In forum General discussion, announcements and releases

8 years ago
That is very Cool!!

In forum Others (Archive)

8 years ago
I love that Dragon! Which file is that?

In forum Others (Archive)

8 years ago
Todd, Be careful with the exotic filaments like Glow-in-the...

In forum Others (Archive)

8 years ago
With the glue, water is your friend. I would wet a paper tow...

In forum Others (Archive)

8 years ago
Thanks for the heads up! I do not plan on a lot of unusual f...

In forum Others (Archive)

8 years ago
I used glue stick on a print and now cannot get it off of th...

In forum Hardware, firmware and software help

8 years ago
I used some of the included stick glue and printed another T...

In forum Others (Archive)

8 years ago
Yes, I used the correct screw as well. Some CA glue and spen...

In forum Others (Archive)

8 years ago
Thanks!

In forum Others (Archive)

8 years ago
Page 1 / 3
Share: