Notifications
Clear all
Tobbe
Group: Registered
Joined: 2020/12/25
Eminent Member
2
|
Accuracy of the extruder temp sensor In forum Hardware, firmware and software help |
4 years ago | |
|
Thanks removing "don't support bridges" did the trick In forum PrusaSlicer |
4 years ago | |
|
Forcing supports in areas the slicer refused to put supports In forum PrusaSlicer |
4 years ago | |
|
In my experience if bed is is tilted left or right when you ... In forum Hardware, firmware and software help |
4 years ago | |
| If you end up having to remove (or replace) the heatbreak an... | 4 years ago | |
| I know this is an obvious question but have you cleaned the ... | 4 years ago | |
|
2.3.0-rc2 and multimaterial issues In forum PrusaSlicer |
4 years ago |
Page 3 / 3
Prev