Aktivita
 
Notifications
Clear all
TJH
TJH
Skupina: Registrovaný
Přidal se: 2018/03/05
Trusted Member
3
Suggestions for first layer improvement?

In forum Assembly and first prints troubleshooting

před 1 year
Configuration bundle release notes?

In forum PrusaSlicer

před 1 year
Configuration bundle release notes?

In forum PrusaSlicer

před 1 year
In slicer, look under "Printer settings", then "extruder" Yo...

In forum Hardware, firmware and software help

před 1 year
Just today (October 7), I was prompted to do a configuration...

In forum Hardware, firmware and software help

před 1 year
Thanks. I think you may have a typo for the housing part #s....

In forum Community mods

před 1 year
My MK4 kit overall works fine (apart from known prusalink/oc...

In forum General discussion, announcements and releases

před 1 year
If you see a flash of LEDs anywhere it's not the same proble...

In forum Assembly and first prints troubleshooting

před 1 year
I'd go for straight PC and print a couple while you are at i...

In forum How do I print this? (Printing help)

před 1 year
Agreed -- organic supports work fine with input shaping. I'm...

In forum Input Shaper (MK4)

před 1 year
My order was on April 5. I just got notice of shipping prep ...

In forum General discussion, announcements and releases

před 1 year
I just posted a picture in the mushroom cloud thread of an ...

In forum Assembly and first prints troubleshooting

před 1 year
Thanks for the info. Where do I find that in the MK4 menu? I...

In forum Assembly and first prints troubleshooting

před 1 year
Always perfect mushroom clouds?

In forum Assembly and first prints troubleshooting

před 1 year
You got a full MK3 to MK4 upgrade kit? I didn't think those...

In forum Assembly and first prints troubleshooting

před 1 year
Hmm, looks like you are pretty under-extruded over the rest ...

In forum Hardware, firmware and software help

před 1 year
Thanks! I had the same issue. I filed a bit of plastic off a...

In forum Assembly and first prints troubleshooting

před 1 year
Has anyone figured out what the actual part #s are for the i...

In forum Community mods

před 1 year
Sock vs XL hot end orientation

In forum Hardware, firmware and software help

před 1 year
Extruder cable holder rubbing against back belts

In forum Assembly and first prints troubleshooting

před 1 year
Stránka 2 / 5
Share: