Notifications
Clear all
Tim G
Tim G
Skupina: Registrovaný
Přidal se: 2020/08/25
Eminent Member
2
ok, just readjusted the pinda sensor. the screw was actuall...

In forum Assembly and first prints troubleshooting

před 4 years
was it not extruding anything or extruding small amount? my...

In forum Assembly and first prints troubleshooting

před 4 years
Did you ever solve your problem? I have the same issue now.

In forum Assembly and first prints troubleshooting

před 4 years
Thanks. Was looking, but not finding anything.

In forum PrusaSlicer

před 4 years
Can you change perimeters or infill above a certain height i...

In forum PrusaSlicer

před 4 years
Checked the belt test and it read 266 for both X and Y. Che...

In forum Hardware, firmware and software help

před 4 years
It doesn't fuse on the first few layers, but by about 5 or 1...

In forum Hardware, firmware and software help

před 4 years
Everything is merging together

In forum Hardware, firmware and software help

před 4 years
thanks, that seems have fixed the wobble. trying a test pri...

In forum Hardware, firmware and software help

před 4 years
print bed wobbles rotationally - MK3s

In forum Hardware, firmware and software help

před 4 years
Prusa Mk3s - print bed has rotational "wobble"

In forum Assembly and first prints troubleshooting

před 4 years
small features turning into blobs - PETG printing

In forum How do I print this? (Printing help)

před 4 years
PLA stringing and globbing on small columns

In forum How do I print this? (Printing help)

před 4 years
Here's a picture. I'm using Matterhackers Build PETG with 1...

In forum How do I print this? (Printing help)

před 4 years
Small holes getting plugged - PETG printing

In forum How do I print this? (Printing help)

před 4 years
ok, I ran your gcode and got very different results. Can yo...

In forum How do I print this? (Printing help)

před 4 years
I just ran the gcode that @jsw linked to.

In forum How do I print this? (Printing help)

před 4 years
So, I ran the tower. There was definitely delamination of l...

In forum How do I print this? (Printing help)

před 4 years
Thanks. Trying to find a good temperature for matterhackers...

In forum How do I print this? (Printing help)

před 4 years
Temperature Tower gcode?

In forum How do I print this? (Printing help)

před 4 years
Stránka 1 / 2
Share: