|
clever, it looks like worst case scenario would be that it p... In forum Others (Archive) |
8 years ago |
|
if you have it enabled, I would turn off forced layer change... In forum Others (Archive) |
8 years ago |
|
the only time I've had the first two errors the fix turned o... In forum Others (Archive) |
8 years ago |
|
if you have it enabled, I would turn off forced layer change... In forum Others (Archive) |
8 years ago |
|
I've got my Y and X belts so tight that the teeth are barely... In forum Others (Archive) |
8 years ago |
|
I suspect that one of my Z motors is skipping steps.
I th... In forum Others (Archive) |
8 years ago |
|
My 3d-printing-fu may be weak, but I've never NOT had to do ... In forum Others (Archive) |
8 years ago |
|
The problem I have with the built in first layer cali is tha... In forum Others (Archive) |
8 years ago |
|
I use a PI3 attached to the headers no problem. I fabricate... In forum Others (Archive) |
8 years ago |
|
Turning the knob (scroll) and reset button works, but pressi... In forum Others (Archive) |
8 years ago |
|
I've had z fail because the trap nut was tightened too much ... In forum Prusa i3 kit (Archive) |
8 years ago |
|
If i change Live-Z during a print or on setting menu it will... In forum Others (Archive) |
8 years ago |
|
Hi James,
Some of the lead screw nuts have been reported to... In forum Others (Archive) |
8 years ago |
|
I too, had a blob that was trapped inside the blue sock, and... In forum Others (Archive) |
8 years ago |
|
In principle I agree, but I've had failures even with a sock... In forum Others (Archive) |
8 years ago |
|
EDIT: Also just optimization for optimization's sake. 🙂
g... In forum Others (Archive) |
8 years ago |
|
Anyway, discuss. 🙂
If I had to guess: The rear of the pr... In forum Others (Archive) |
8 years ago |
|
Trawl forums & blogs yourself, Prusa won't contact you.
... In forum Others (Archive) |
8 years ago |
|
235-240, 55mms overall and 50% perimeters. .75 retract at 3... In forum Others (Archive) |
8 years ago |
|
Couldn't the sensor be calibrated to the filament at the sta... In forum Improvements (Archive) |
8 years ago |
