|
Thermistor Increasing Temp In forum Hardware, firmware and software help |
5 years ago |
|
That was indeed exactly my issue. I had absolutely used a t... In forum Hardware, firmware and software help |
6 years ago |
|
I definitely swapped the tube when I upgraded the exturder (... In forum Hardware, firmware and software help |
6 years ago |
|
I'm 99.9% sure that I used one of the 2 1.85mm inner diamter... In forum Hardware, firmware and software help |
6 years ago |
|
Filament Head Diameter In forum Hardware, firmware and software help |
6 years ago |
|
Having to be there to cut the end of a spool kinda defeats t... In forum Hardware, firmware and software help |
6 years ago |
|
Spool Join Run Out Not retracting In forum Hardware, firmware and software help |
6 years ago |
|
Color Print Partially Working In forum Hardware, firmware and software help |
6 years ago |
|
My MMU2.0 arrived but I have not had time to assmeble and st... In forum General discussion, announcements and releases |
6 years ago |
|
I've tried atomic pulling, and they seemed to come out clean... In forum Hardware, firmware and software help |
7 years ago |
|
I happened to clip the filament just at/above the gear notch... In forum Hardware, firmware and software help |
7 years ago |
|
I've tried atomic pulling, and they seemed to come out clean... In forum Hardware, firmware and software help |
7 years ago |
|
Extruder clicking and jamming after nearly every good print In forum Hardware, firmware and software help |
7 years ago |
|
What camera setup are you using for time-lapses? I'm lookin... In forum Awesome prints (Hall Of Fame) |
7 years ago |
|
CA (super) glue has worked great for me, though I'd recommen... In forum General discussion, announcements and releases |
7 years ago |
|
I'll change from working great, to working some of the time.... In forum Improvements (Archive) |
7 years ago |
|
I'm using 1.3.7rc2 and it's working great with the MK3. I s... In forum Improvements (Archive) |
7 years ago |
|
Strange Extruder noise In forum Others (Archive) |
7 years ago |
|
1) Octoprint doesn't seem to register that the printer has s... In forum General discussion, announcements and releases |
7 years ago |
|
I actually saw that last night when I saw there was a notifi... In forum General discussion, announcements and releases |
7 years ago |
