Prusa3D Forum

Notifications

Clear all

taylorstrait

Group: Registered

Joined: 2019/07/21

Active Member

	Thanks for all the feedback. After trying adjusting the temp... In forum How do I print this? (Printing help)	5 years ago
	My retraction distance is 1mm and retraction speed is 45mm/s... In forum How do I print this? (Printing help)	5 years ago
	Print either fails or has low quality only on "Gap Fill" sec... In forum How do I print this? (Printing help)	5 years ago
	I believe the issue has been resolved (fingers crossed!) -- ... In forum Assembly and first prints troubleshooting	5 years ago
	I have reset the grub screws (I paid close attention and saw... In forum Assembly and first prints troubleshooting	5 years ago
	Grub screws have been 3x checked and tightened. Flat screw f... In forum Assembly and first prints troubleshooting	5 years ago
	I do show crashes: 8 power failures, 5 x-axis crashes and 9 ... In forum Assembly and first prints troubleshooting	5 years ago
	I tried to lower the tension on both sets of bearings, but i... In forum Assembly and first prints troubleshooting	5 years ago
	Thanks for chiming in. When checking the movement of my axes... In forum Assembly and first prints troubleshooting	5 years ago
	At my wit's end with Y-layer shifting In forum Assembly and first prints troubleshooting	5 years ago

Forum Statistics

565 Forums

63.6 K Topics

446.4 K Posts

21 Online

69 K Members

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed