Notifications
Clear all
tammets
Group: Registered
Joined: 2017/10/12
Active Member
1
|
@raymate In forum Hardware, firmware and software help |
5 years ago | |
|
Agree and tried that too but after removing an old fan it tu... In forum Hardware, firmware and software help |
5 years ago | |
|
Had a similar noise issue with print fan and eventually just... In forum Hardware, firmware and software help |
5 years ago | |
| RE: Overture PLA 1.75mm | 5 years ago | |
|
Check the tension of the idler on the springed-screw. In forum Hardware, firmware and software help |
5 years ago | |
| @prophageus | 6 years ago | |
| @prophageus Try to rise printing temperatures, 235C for PLA. | 6 years ago | |
| Thats something I noticed too, I managed to loosen 2 screws ... | 6 years ago |