Notifications
Clear all
Sunshadow
Group: Registered
Joined: 2017/04/25
Active Member
1
|
I was wrong, the Fan setting controls the front print fan, n... In forum Hardware, firmware and software help |
4 years ago | |
|
I checked the fans. When I reduce the speed in the printer m... In forum Hardware, firmware and software help |
4 years ago | |
|
Hmmm... not sure. How can I identify the correct fan? In forum Hardware, firmware and software help |
4 years ago | |
|
Fan speed at 255 In forum Hardware, firmware and software help |
4 years ago | |
| Thank you. Already found the problem! The hotend wasn't tigh... | 6 years ago | |
| MK3S Upgrade - Hotend loose | 6 years ago | |
| Problem with first layer | 7 years ago | |
|
Remove stuck PLA from nozzle and heatbraeker In forum Hardware, firmware and software help |
7 years ago | |
|
Problems with calibration - Stringing In forum Hardware, firmware and software help |
8 years ago |