|
I have only done what the instructions require. I checked ... In forum Hardware, firmware and software help |
1 month ago |
|
I am having the same issue. I posted it as an answer on a ... In forum Assembly and first prints troubleshooting |
1 month ago |
|
I have had similar issues. I have the MK4 kit, which I boug... In forum Hardware, firmware and software help |
1 month ago |
|
Mine showed up today, a day early, according to DHL. 05.0... In forum General discussion, announcements and releases |
4 years ago |
|
Another view. Heat distortion.
20200624_093816.jpg In forum How do I print this? (Printing help) |
4 years ago |
|
Finished the print, over 50 hours, and it looks like crap. ... In forum How do I print this? (Printing help) |
4 years ago |
|
And last settings page. Any info would be great. Thanks
... In forum How do I print this? (Printing help) |
4 years ago |
|
And more.
2020-06-22-8.png In forum How do I print this? (Printing help) |
4 years ago |
|
More settings
2020-06-22-6.png In forum How do I print this? (Printing help) |
4 years ago |
|
Here are my Slic3r settings.
2020-06-22-3.png In forum How do I print this? (Printing help) |
4 years ago |
|
As much as I'd prefer to not have supports, Slic3r seems to ... In forum How do I print this? (Printing help) |
4 years ago |
|
Here's a CAD screen shot of the fix I'm about to try, if the... In forum How do I print this? (Printing help) |
4 years ago |
|
This is another part for the same project I'm working on. T... In forum How do I print this? (Printing help) |
4 years ago |
|
This is a contact surface, on top of some supports. This is... In forum How do I print this? (Printing help) |
4 years ago |
|
An earlier failed first pass. I run them very slow. While ... In forum How do I print this? (Printing help) |
4 years ago |
|
What is the trick with PETG? In forum How do I print this? (Printing help) |
4 years ago |
|
I finally received the "shipped" email. Paid 05.06.20, shi... In forum General discussion, announcements and releases |
4 years ago |
|
This is my second time ordering, and it's the same as it was... In forum General discussion, announcements and releases |
4 years ago |
|
There's more where that one came from... but it fit the bill... In forum General discussion, announcements and releases |
6 years ago |
|
New Injection Molded Dual-Spool Holder In forum General discussion, announcements and releases |
7 years ago |
