|
Posted it over here: and was told it belongd in the slicer ... Nel forum PrusaSlicer |
5 years fa |
|
It's all good. Thanks for the info. I used to do lots of c... Nel forum PrusaSlicer |
5 years fa |
|
Ok. I will. Nel forum PrusaSlicer |
5 years fa |
|
I don't mean to beat this to death, but just to make it as c... Nel forum PrusaSlicer |
5 years fa |
|
Really? That's expected behavior? Yes, I have been removin... Nel forum PrusaSlicer |
5 years fa |
|
Thanks for the reply. But that's not the bug I was talking ... Nel forum PrusaSlicer |
5 years fa |
|
Thank you. I will. I have been printing some nameplates wi... Nel forum PrusaSlicer |
5 years fa |
|
Using the plus mark on the slider in PrusaSlicer. Nel forum PrusaSlicer |
5 years fa |
|
Same firmware? I'm on 3.7.1? I have a MK3 that was upgrade... Nel forum PrusaSlicer |
6 years fa |
|
Yes I suppose I could. But I remember doing a lot of color ... Nel forum PrusaSlicer |
6 years fa |
|
PrusaSlicer Color Change returns to poor location, maybe it'... Nel forum PrusaSlicer |
6 years fa |
|
I'm not sure about #1. I'm guessing #2 is because you have ... Nel forum Hardware, firmware and software help |
6 years fa |
|
I don't want to muck about with custom g-code to get 7x7.
... Nel forum Hardware, firmware and software help |
6 years fa |
|
You can try this solution on the Czech forum ...
It ap... Nel forum Hardware, firmware and software help |
6 years fa |
|
Does setting mesh to turn on magnet compensation help?
Tha... Nel forum Hardware, firmware and software help |
6 years fa |
|
I re-ran the entire calibration wizard, twice. Each time I... Nel forum Hardware, firmware and software help |
6 years fa |
|
MK3S 3.7.0 RC1 firmware 7x7 bed leveling fails 50% of the ti... Nel forum Hardware, firmware and software help |
6 years fa |
|
No worries, my friend. I'm glad you figured out your issue ... Nel forum Hardware, firmware and software help |
6 years fa |
|
Yes, but I believe you are trying to fix a symptom not by fi... Nel forum Hardware, firmware and software help |
6 years fa |
|
Can you superlube the rods while the bearings are attached a... Nel forum Hardware, firmware and software help |
6 years fa |
