Notifications
Clear all
steven.m25
steven.m25
Group: Registered
Joined: 2018/05/22
Eminent Member
2
Posted it over here: and was told it belongd in the slicer ...

In forum PrusaSlicer

5 years ago
It's all good. Thanks for the info. I used to do lots of c...

In forum PrusaSlicer

5 years ago
Ok. I will.

In forum PrusaSlicer

5 years ago
I don't mean to beat this to death, but just to make it as c...

In forum PrusaSlicer

5 years ago
Really? That's expected behavior? Yes, I have been removin...

In forum PrusaSlicer

5 years ago
Thanks for the reply. But that's not the bug I was talking ...

In forum PrusaSlicer

5 years ago
Thank you. I will. I have been printing some nameplates wi...

In forum PrusaSlicer

6 years ago
Using the plus mark on the slider in PrusaSlicer.

In forum PrusaSlicer

6 years ago
Same firmware? I'm on 3.7.1? I have a MK3 that was upgrade...

In forum PrusaSlicer

6 years ago
Yes I suppose I could. But I remember doing a lot of color ...

In forum PrusaSlicer

6 years ago
PrusaSlicer Color Change returns to poor location, maybe it'...

In forum PrusaSlicer

6 years ago
I'm not sure about #1. I'm guessing #2 is because you have ...

In forum Hardware, firmware and software help

6 years ago
I don't want to muck about with custom g-code to get 7x7. ...

In forum Hardware, firmware and software help

6 years ago
You can try this solution on the Czech forum ... It ap...

In forum Hardware, firmware and software help

6 years ago
Does setting mesh to turn on magnet compensation help? Tha...

In forum Hardware, firmware and software help

6 years ago
I re-ran the entire calibration wizard, twice. Each time I...

In forum Hardware, firmware and software help

6 years ago
MK3S 3.7.0 RC1 firmware 7x7 bed leveling fails 50% of the ti...

In forum Hardware, firmware and software help

6 years ago
No worries, my friend. I'm glad you figured out your issue ...

In forum Hardware, firmware and software help

6 years ago
Yes, but I believe you are trying to fix a symptom not by fi...

In forum Hardware, firmware and software help

6 years ago
Can you superlube the rods while the bearings are attached a...

In forum Hardware, firmware and software help

6 years ago
Page 1 / 2
Share: