stephen.e3 – Aktivita – Prusa3D Forum

Notifications

Clear all

stephen.e3

Skupina: Registrovaný

Přidal se: 2016/09/30

Estimable Member

	How was V2Calibration created? In forum Others (Archive)	před 8 years
	It looks pretty good to me. I too have been having and cont... In forum Others (Archive)	před 8 years
	I think opinion is still very mixed on how dangerous 3d prin... In forum Others (Archive)	před 8 years
	Checked all wires, nothing seems damaged. I can't see the v... In forum Others (Archive)	před 8 years
	Confirmed, it is not affected by Low Power mode. Takes just... In forum Others (Archive)	před 8 years
	Weird... My room is warmer than that and it takes at least t... In forum Others (Archive)	před 8 years
	Great video that demystifies the process for me. Thanks for... In forum Others (Archive)	před 8 years
	It is in my loft. Temperature up there is about 25 degrees ... In forum Others (Archive)	před 8 years
	Bed take ages to reach temperature for ABS In forum Others (Archive)	před 8 years
	So long as I am pulling on the filament, I only ever have to... In forum Others (Archive)	před 8 years
	For anybody else that runs into this issue, ignore the offic... In forum Prusa i3 kit (Archive)	před 8 years
	I've printed the protector in ABS using the supplied GCODE f... In forum Prusa i3 kit (Archive)	před 8 years
	The black threaded piece is the right way around, on the top... In forum Others (Archive)	před 8 years
	Thanks. It does the same with different filaments so I don'... In forum Others (Archive)	před 8 years
	Great thanks. That is clearer. No the X-Axis is not perfec... In forum Others (Archive)	před 8 years
	Not easy to measure, but from what I can tell both of these ... In forum Others (Archive)	před 8 years
	Thanks, but I get the same results using the included models... In forum Others (Archive)	před 8 years
	What keeps the Z-Axis level? In forum Others (Archive)	před 8 years
	I don't know if this is normal, but I have noticed that the ... In forum Others (Archive)	před 8 years
	It is similar, but the marks and number of them are not in t... In forum Others (Archive)	před 8 years

Stránka 5 / 6 Předchozí Další

Fórum Statistiky

559 Fóra

62.7 K Témata

442.2 K Příspěvky

20 Online

67.3 K Uživatelé

Poslední Příspěvek: Changing Filament 0% Finishing Buffered gcodes Nový Uživatel: pinklemonade Recent Posts Unread Posts Tags

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed