|
Thanks Peter.
I've bought some of the Capricorn Bowden tubi... In forum Hardware, firmware and software help |
7 years ago |
|
No matter what I tried this would not let me release the hot... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks Peter. I'll give that a go. I appreciate the patien... In forum Hardware, firmware and software help |
7 years ago |
|
I have already removed those. However, the hotend is still ... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks for the detailed description Peter, I will see if I c... In forum Hardware, firmware and software help |
7 years ago |
|
Thanks Peter. In forum Hardware, firmware and software help |
7 years ago |
|
Thanks. Sorry, I hadn't noticed I had posted it to the wron... In forum Hardware, firmware and software help |
7 years ago |
|
Blockage near cold end of hotend In forum Hardware, firmware and software help |
7 years ago |
|
I've got this problem now. I have a jam about 3cm into the... In forum Prusa i3 kit (Archive) |
7 years ago |
|
I too would like to know if anyone has actually wired this u... In forum Improvements (Archive) |
8 years ago |
|
No I didn't. It is partially displayed like that in the sli... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Noticed a similar amount of under-extrusion on the FlashForg... In forum Prusa i3 kit (Archive) |
8 years ago |
|
Underextrusion In forum Prusa i3 kit (Archive) |
8 years ago |
|
I can confirm that Z offset is the key issue here. Now most... In forum Others (Archive) |
8 years ago |
|
Ok thanks. I will try those suggestions. It is a frustrati... In forum Others (Archive) |
8 years ago |
|
Help... The fishscale pattern is back In forum Others (Archive) |
8 years ago |
|
Thanks for posting your results Jens. That looks excellent.... In forum Others (Archive) |
8 years ago |
|
Wow, nice offer, thanks.
I replaced my PEI sheet with the o... In forum Others (Archive) |
8 years ago |
|
I can confirm that using Turpentine (White Spirits) works to... In forum Others (Archive) |
8 years ago |
|
Thanks for these suggestions of how to replace it without re... In forum Others (Archive) |
8 years ago |
