stellr – Aktywność – Prusa3D Forum

Notifications

Clear all

stellr

Grupa: Zarejestrowany

Dołączył: 2019/09/24

Trusted Member

	clumps on direction changes In forum How do I print this? (Printing help)	4 years temu
	This comment made me wonder if I was missing something. I g... In forum PrusaSlicer	5 years temu
	gcode import In forum PrusaSlicer	5 years temu
	This same printer finally failed and started putting out thi... In forum Print tips (Archive)	5 years temu
	improve extrusion suggestions In forum Print tips (Archive)	5 years temu
	@joantabb Not a slicer/model issue, as I've been using this ... In forum Print tips (Archive)	5 years temu
	Yes, only the 9 points. I'll take a look at the 7x7. I rea... In forum Hardware, firmware and software help	5 years temu
	layers not sticking In forum Print tips (Archive)	5 years temu
	I'm a newbie and it turns out I needed to fine adjust the Z ... In forum Hardware, firmware and software help	5 years temu
	@karl-herbert I don't understand "loading the filament manua... In forum Hardware, firmware and software help	5 years temu
	MK3S hot end replacement fail In forum Hardware, firmware and software help	5 years temu

Strona 3 / 3 Wstecz

Statystyki Forum

565 Fora

63.6 K Tematy

446.2 K Posty

26 Online

69 K Członkowie

Forum Icons: Forum contains no unread posts Forum contains unread posts

Ikony tematu: Not Replied Odwpowiedzi Aktywny Gorący Przyklejony Unapproved Rozwiązany Private Zamknięte