stellr – Aktivita – Prusa3D Forum

Notifications

Clear all

stellr

Skupina: Registrovaný

Přidal se: 2019/09/24

Trusted Member

	clumps on direction changes In forum How do I print this? (Printing help)	před 4 years
	This comment made me wonder if I was missing something. I g... In forum PrusaSlicer	před 5 years
	gcode import In forum PrusaSlicer	před 5 years
	This same printer finally failed and started putting out thi... In forum Print tips (Archive)	před 5 years
	improve extrusion suggestions In forum Print tips (Archive)	před 5 years
	@joantabb Not a slicer/model issue, as I've been using this ... In forum Print tips (Archive)	před 5 years
	Yes, only the 9 points. I'll take a look at the 7x7. I rea... In forum Hardware, firmware and software help	před 5 years
	layers not sticking In forum Print tips (Archive)	před 5 years
	I'm a newbie and it turns out I needed to fine adjust the Z ... In forum Hardware, firmware and software help	před 5 years
	@karl-herbert I don't understand "loading the filament manua... In forum Hardware, firmware and software help	před 5 years
	MK3S hot end replacement fail In forum Hardware, firmware and software help	před 5 years

Stránka 3 / 3 Předchozí

Fórum Statistiky

565 Fóra

63.9 K Témata

447.9 K Příspěvky

18 Online

69.6 K Uživatelé

Forum Icons: Forum contains no unread posts Forum contains unread posts

Topic Icons: Not Replied Replied Active Hot Sticky Unapproved Solved Private Closed