Notifications
Clear all
solomon.c
solomon.c
Group: Registered
Joined: 2016/12/03
Eminent Member
2
This just happened to me a few days ago, after printing very...

In forum Others (Archive)

7 years ago
This just happened to me a few days ago, after printing very...

In forum Others (Archive)

7 years ago
After a few days the new springs stopped working and while t...

In forum Others (Archive)

7 years ago
I found a blob of something in the heat break after disassem...

In forum Others (Archive)

7 years ago
I've also been having issues with extrusion. I've been tryi...

In forum Others (Archive)

7 years ago
Wondering if I have this kind of issue or something else. I ...

In forum Others (Archive)

7 years ago
Update: I've been having lots of problems with under-extrus...

In forum Others (Archive)

7 years ago
old filament (which may have soaked up moisture) requires hi...

In forum Others (Archive)

7 years ago
Forgot to mention that it's just a generic filament from a l...

In forum Others (Archive)

7 years ago
Finally Printing - Extruder Temp Question

In forum Others (Archive)

7 years ago
Here is my starter advice for getting your printer going wel...

In forum Others (Archive)

7 years ago
Not sure how to get the image to show, the url is

In forum Others (Archive)

7 years ago
1st Layer Advice

In forum Others (Archive)

7 years ago
Update: I have a working printer now after sorting out a rep...

In forum Others (Archive)

7 years ago
I have sent a message to support as well.

In forum Others (Archive)

7 years ago
Ok, I have tested the wires without the connector (cut the c...

In forum Others (Archive)

7 years ago
With my first generation Prusa (Do we call it a MK1 now?), I...

In forum Others (Archive)

7 years ago
I read in another post that there should be continuity throu...

In forum Others (Archive)

7 years ago
For lack of a better idea, I removed the z-axis motors and t...

In forum Others (Archive)

7 years ago
If you've done the steps identified in this video, then I do...

In forum Others (Archive)

7 years ago
Page 1 / 2
Share: