Notifications
Clear all
SocialMisanthrope
SocialMisanthrope
Group: Registered
Joined: 2026/01/13
Active Member
1
I assembled mine too, but I don't know if I would do it agai...

In forum Assembly and first prints troubleshooting

2 hours ago
I removed it from mine and it was a night and day difference...

In forum Assembly and first prints troubleshooting

2 hours ago
Have you tried this?br />this fixed the major issue I was ha...

In forum Assembly and first prints troubleshooting

8 hours ago
I'll have to do that tomorrow, the Ambien is kicking in.I bo...

In forum Assembly and first prints troubleshooting

20 hours ago
oh friend I'm not expecting you to go out of your way or any...

In forum Assembly and first prints troubleshooting

20 hours ago
posting a youtube link to video in case it's not showing. wi...

In forum Assembly and first prints troubleshooting

22 hours ago
RE:

In forum Assembly and first prints troubleshooting

22 hours ago
hope this video posts, had to compress it twice

In forum Assembly and first prints troubleshooting

22 hours ago
Now, when you say "excessive banging", it *is* suppose to ba...

In forum Assembly and first prints troubleshooting

23 hours ago
Ok, so:1) Reattached the tension belt pulleys2) Tightened bo...

In forum Assembly and first prints troubleshooting

23 hours ago
I loosened too much and the belts came undone. Not a problem...

In forum Assembly and first prints troubleshooting

1 day ago
it's all good. I'm just gonna wait for the accelerometer to ...

In forum Assembly and first prints troubleshooting

1 day ago
1) Belt tensioning- I broke the right printed front tension ...

In forum Assembly and first prints troubleshooting

2 days ago
Sorry if I'm being dense or hard to understand, I'm not good...

In forum Assembly and first prints troubleshooting

2 days ago
I got the file from printables, the STL file,/p>

In forum Assembly and first prints troubleshooting

2 days ago
Did not and have not used stealth mode yet

In forum Assembly and first prints troubleshooting

2 days ago
Possible ghosting issues after calibration

In forum Assembly and first prints troubleshooting

3 days ago
Share: