Notifications
Clear all
Snapshotz - all you can print
Skupina: Registrovaný
Přidal se: 2020/03/27
Active Member
1
|
@gerard-maas to much tension and then the motor sliped In forum Hardware, firmware and software help |
před 6 years | |
|
I HAD THE SAME ISSUE I found the solution here in an other p... In forum Hardware, firmware and software help |
před 6 years | |
| Always clean your sheet plate. I always use an inexpensive a... | před 6 years | |
| Almost perfect. | před 6 years | |
| @neophyl Hey Neophyl, thanks for your support, yes, you figu... | před 6 years | |
| @nilok Hey nilok, thanks for your feedback. I always clean t... | před 6 years | |
| WTF. I can calibrate the printer as much as I want to but th... | před 6 years | |
| @neophyl Thanks for your feedback. Yes it is correct the Hea... | před 6 years | |
| Extruder changes its position during print | před 6 years |