English
Forums
Members
Sebastianmaklary
Activity
 
Notifications
Clear all
Sebastianmaklary
Sebastianmaklary
Group: Registered
Joined: 2017/09/29
Eminent Member
2
Profile Activity
Just an update: after using my intake funnel and duct I'm no...

In forum Improvements (Archive)

 8 years ago
I just noticed that the three "arms" are shaped like air foi...

In forum Improvements (Archive)

 8 years ago
I often get those "Bubbles" If I remove a print that sticks ...

In forum Others (Archive)

 8 years ago
I've only printed almost 1 kg of the filament that was shipp...

In forum Hardware, firmware and software help

 8 years ago
Your fan nozzle/shroud works great! KUDOS...I need to try th...

In forum Improvements (Archive)

 8 years ago
Your intake funnel is also known as a "velocity stack"...the...

In forum Improvements (Archive)

 8 years ago
Make sure that your bed is clean. I wipe it with ethanol bef...

In forum Others (Archive)

 8 years ago
Just an update: after using my intake funnel and duct I'm no...

In forum Improvements (Archive)

 8 years ago
Thanks for the hint of cooling the enclosure rather than rec...

In forum Others (Archive)

 8 years ago
Mine also rattles at certain frequencies but this is on the ...

In forum Others (Archive)

 8 years ago
I see yours loads standing on end. What is the best orienta...

In forum Improvements (Archive)

 8 years ago
I hold a lighter against the print to get rid of the fine ha...

In forum Improvements (Archive)

 8 years ago
First layer of support material won't stick

In forum Print tips (Archive)

 8 years ago
I'm currently using this one with pretty good results: Ye...

In forum Improvements (Archive)

 8 years ago
Hose clamps in x ends for bearings

In forum Others (Archive)

 9 years ago
Page 2 / 2
Share: