Notifications
Clear all
screw_ball69
Group: Registered
Joined: 2018/03/06
Eminent Member
2
|
Z-Level not consistent on multiple prints In forum Hardware, firmware and software help |
7 years ago | |
|
How hot should the motors get? In forum Hardware, firmware and software help |
7 years ago | |
|
No issues untill recently and with certain paterns. In forum How do I print this? (Printing help) |
7 years ago | |
|
If you hold the “raft” against a light, do you see light com... In forum How do I print this? (Printing help) |
7 years ago | |
|
Problems printing Quad Bearing In forum How do I print this? (Printing help) |
7 years ago | |
| I'm a idiot apparently I was thinking of E-Correct being off | 7 years ago | |
| 3.2.1 firmware is a must on MK3. With linear advance you wil... | 7 years ago | |
| This helped greatly in getting things printing smoothly. I ... | 7 years ago |
Page 2 / 2
Prev