|
I had just tried unplugging from the wall and plugging it ba... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
So I had plugged in the extruder thermister and turned it on... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I'm getting a min temp error. should I put in the hot end th... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Just starting it up now. Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I have the heatbed plugged in on the bottom but did you mean... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I removed the extruder motor plug in. Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Right now I have all the motors the pinda probe, the lcd cab... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Just disconnected the things not mentioned and it has turned... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I'll turn it off and try disconnecting a few of the items Im Forum Hardware, firmware and software help |
Vor 2 years |
|
just plugged everything in and it started up what appears to... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
not just yet. fuses are good. I'm just popping everything ba... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I can check them again here Im Forum Hardware, firmware and software help |
Vor 2 years |
|
it was before I had a partial print come off tonight. thpar... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
Fuses are good I had checked them before. If the einsy was b... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
not turning on, when i flipped on the power the screen flash... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
those are all plugged in now with the pinda. Im Forum Hardware, firmware and software help |
Vor 2 years |
|
so pinda, filament snsor, front print fan, left hotend fan, ... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
that's teh block with the two thicker red wires. I've also g... Im Forum Hardware, firmware and software help |
Vor 2 years |
|
So the extruder heater is coming in at 15.2 ohms Im Forum Hardware, firmware and software help |
Vor 2 years |
|
I had checked that and the bed one as well. I'm assuming you... Im Forum Hardware, firmware and software help |
Vor 2 years |
