|
It did! It turned out great. I'm halfway through a second pr... In forum Hardware, firmware and software help |
2 years ago |
|
So far so good. it's made it past the point of shut off from... In forum Hardware, firmware and software help |
2 years ago |
|
Well thank you again for all the help I'll give this thread ... In forum Hardware, firmware and software help |
2 years ago |
|
I managed to unload and load filament no problem, I have a s... In forum Hardware, firmware and software help |
2 years ago |
|
So first time I went to turn it on it was stuck on the loadi... In forum Hardware, firmware and software help |
2 years ago |
|
going to give that a whirl. hang tight. In forum Hardware, firmware and software help |
2 years ago |
|
Set it to 270 it went up to 275 then settled down to 270 sho... In forum Hardware, firmware and software help |
2 years ago |
|
The nozzle kept trying to go to zero so I have the two fans ... In forum Hardware, firmware and software help |
2 years ago |
|
I've got the hot end heating up at the moment. I set it to 2... In forum Hardware, firmware and software help |
2 years ago |
|
Made it to 80 then turned off the bed, but no issues sitting... In forum Hardware, firmware and software help |
2 years ago |
|
Every terminal has been cleaned up along with the spade lugs... In forum Hardware, firmware and software help |
2 years ago |
|
Can do! I apprecaite all the help btw! In forum Hardware, firmware and software help |
2 years ago |
|
if you look between screws 2 and 3 it looks like there's som... In forum Hardware, firmware and software help |
2 years ago |
|
RE: Max temp error, then blank screen, now printer stops whi... In forum Hardware, firmware and software help |
2 years ago |
|
I think we found the problem. Let me take a photo In forum Hardware, firmware and software help |
2 years ago |
|
How can I check power coming out of the psu with the multime... In forum Hardware, firmware and software help |
2 years ago |
|
PSU fuse is still good In forum Hardware, firmware and software help |
2 years ago |
|
sorry let me check the psu fuse. In forum Hardware, firmware and software help |
2 years ago |
|
15 amp fuse is still good. In forum Hardware, firmware and software help |
2 years ago |
|
Just plugged it back in and nothing is firing up. The board ... In forum Hardware, firmware and software help |
2 years ago |
