Notifications
Clear all
Sander
Group: Registered
Joined: 2021/08/15
Active Member
1
|
cwbullet: yes, as Ive already said, Ive had the Prusa for 4 ... In forum Hardware, firmware and software help |
4 years ago | |
|
not sure why the video is not showing up. here is the link: ... In forum Hardware, firmware and software help |
4 years ago | |
|
here is videos showing the issue. The faulty PINDA is passin... In forum Hardware, firmware and software help |
4 years ago | |
|
ok I have resolved the issue. I contacted support and we sp... In forum Hardware, firmware and software help |
4 years ago | |
|
Thank you for all your advice for drying filament. I will lo... In forum Hardware, firmware and software help |
4 years ago | |
|
I spent another long night, hours troubleshooting the "some ... In forum Hardware, firmware and software help |
4 years ago | |
|
Many Issues with Prusa In forum Hardware, firmware and software help |
4 years ago | |
| PETG edges peeling off | 4 years ago | |
| I noticed that the grub on the X-axis motor was sliding. I t... | 4 years ago | |
| layer skip | 4 years ago |