Activity
 
Notifications
Clear all
Sam
Sam
Group: Registered
Joined: 2019/07/01
Active Member
1
I think they load it in a truck and just drive circles aroun...

In forum General discussion, announcements and releases

5 years ago
I was a bit apprehensive when I unpacked everything but I sp...

In forum General discussion, announcements and releases

5 years ago
Finished putting my MK3S kit together yesterday. Printed a c...

In forum General discussion, announcements and releases

5 years ago
I hope to see Prusa move to more expensive printers and hope...

In forum General discussion, announcements and releases

5 years ago
Hope it is smooth from here. Not sure I would blame Prusa fo...

In forum General discussion, announcements and releases

5 years ago
I'm mechanically inclined, I should be able to build this.

In forum General discussion, announcements and releases

5 years ago
DHL picked it up on July 4th and it was in Minn. on the 8th....

In forum General discussion, announcements and releases

5 years ago
DHL is messin' with me.

In forum General discussion, announcements and releases

5 years ago
Are you building an enclosure?

In forum General discussion, announcements and releases

5 years ago
I probably would have blamed a botched firmware update befor...

In forum General discussion, announcements and releases

5 years ago
Yes the CR-10 S5 I think is 50cm x 50cm x 50cm but I also be...

In forum General discussion, announcements and releases

5 years ago
Ordered this morning. I went over my "Novice Printer Budget"...

In forum General discussion, announcements and releases

5 years ago
I will be ordering my first printer tomorrow. I was only wai...

In forum General discussion, announcements and releases

5 years ago
Share: