|
Not yet. They decided that there maybe a bad chip on the bud... In forum General discussion, announcements and releases |
14 hours ago |
|
Yup, I tried that also, no happiness. I run my fan on a 12 v... In forum General discussion, announcements and releases |
6 days ago |
|
Thay have decided I have a bad memory chip as a minimum. The... In forum General discussion, announcements and releases |
2 weeks ago |
|
No, five months of issues. Slow customer support. It has cos... In forum General discussion, announcements and releases |
2 weeks ago |
|
They have decided to replace the Buddy board and both printh... In forum General discussion, announcements and releases |
2 weeks ago |
|
Two MK3S+ and one other . In forum General discussion, announcements and releases |
2 weeks ago |
|
I hope it works. I haven't heard from support in over a week... In forum General discussion, announcements and releases |
3 weeks ago |
|
I have three other printers working on the same mains circui... In forum General discussion, announcements and releases |
3 weeks ago |
|
Side sensors have been disabled for a while. Yes I can feed ... In forum General discussion, announcements and releases |
4 weeks ago |
|
Extruder stops and only starts with a shut down and reboot. ... In forum General discussion, announcements and releases |
4 weeks ago |
|
So it seems this is happening to others not on this forum. O... In forum General discussion, announcements and releases |
4 weeks ago |
|
Yes, but in my case and several others the extruder just sud... In forum General discussion, announcements and releases |
4 weeks ago |
|
They are not very keen on it. Getting stuff shipped out of G... In forum General discussion, announcements and releases |
4 weeks ago |
|
Starting from a quality USB. 85 degrees ambient with the las... In forum General discussion, announcements and releases |
4 weeks ago |
|
Well the one printhead that seemed to be working stopped ext... In forum General discussion, announcements and releases |
1 month ago |
|
I have, they are not thrilled with the idea. We'll see. What... In forum General discussion, announcements and releases |
1 month ago |
|
One head prints ok much of the time the other is not able to... In forum General discussion, announcements and releases |
1 month ago |
|
Yes, I even swapped them out and the problem stays with it. In forum General discussion, announcements and releases |
1 month ago |
|
I'll be honest. I feel customer support at this point is giv... In forum General discussion, announcements and releases |
1 month ago |
|
That name is a curse word around our place! In forum General discussion, announcements and releases |
1 month ago |
